Instrument an
d
control functions
4-18
4
To install the rider seat
1. Insert the projection on the front of
the rider seat into the seat holder
as shown, and then place the seat
in the original position.
2. Install the bolts with the hexagon
wrench.
3. Insert the hexagon wrench back
into its holder on the rider seat.
4. Install the passenger seat.
TIP
Make sure that the seats are properly
secured before riding.
EAU90940
A
d
justin
g
the hea
d
li
g
ht
b
eams
The headlight beam can be adjusted to
raise or lower the height of the head-
light beams. It may be necessary to ad-
just the headlight beams to increase
visibility and help prevent blinding on-
coming drivers when carrying more or
less load than usual. Obey local laws
and regulations concerning headlight
adjustment.
If headlights require adjustment, con-
sult a Yamaha dealer.
EAU45205
A
d
justin
g
the front fork
WARNING
EWA10181
Always a
d
just
b
oth fork le
g
s equally,
otherwise poor han
d
lin
g
an
d
loss of
sta
b
ility may result.
This front fork is equipped with re-
bound damping force adjusting screws
and compression damping force ad-
justing screws.
NOTICE
ECA10102
To avoi
d
d
ama
g
in
g
the mechanism,
d
o not attempt to turn
b
eyon
d
the
maximum or minimum settin
g
s.
Re
b
oun
d
d
ampin
g
force
Turn the adjusting screw in direction (a)
to increase the rebound damping
force.
Turn the adjusting screw in direction (b)
to decrease the rebound damping
force.
To set the rebound damping force, turn
the adjuster in direction (a) until it
stops, and then count the clicks in di-
rection (b).
1. Projection
2. Seat holder
1
2
UBAU10E0.book Page 18 Monday, February 17, 2020 10:12 AM
