Instrument and control functions
4-12
1
2
3
4
5
6
7
8
9
10
11
12
of the traction control system and
the TCS settings.
EAU68270
Start/Engine stop switch “
/
/
”
To crank the engine with the starter, set
this switch to “
”, and then slide the
switch toward “
”. See page 6-2 for
starting instructions prior to starting the
engine.
Set this switch to “
” to stop the engine
in case of an emergency, such as when
the vehicle overturns or when the throt-
tle cable is stuck.
EAU12735
Hazard switch “
”
With the key in the “ON” or “
” posi-
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
ECA10062
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU73321
Drive mode switch “MODE”
WARNING
EWA18440
Do not change the drive mode while
the vehicle is moving.
With the throttle grip closed, press this
switch to change the drive mode (page
4-10) in the following order:
A
B
STD
A
TIP
The current drive mode is shown in
the drive mode display (page 4-6).
The current drive mode is saved
when the vehicle is turned off.
EAU12823
Clutch lever
To disengage the drivetrain from the
engine, such as when shifting gears,
pull the clutch lever toward to the han-
dlebar. Release the lever to engage the
clutch and transmit power to the rear
wheel.
TIP
The lever should be pulled rapidly and
released slowly for smooth shifting.
(See page 6-3.)
1. Clutch lever
1
BAE-28199-12.book 12 ページ 2020年7月28日 火曜日 午前10時8分