Yamaha XSR125, Owner'S Manual

Page: 32 / 90

Instrument an d control functions
3-17
3
EAU14314
Helmet hol d er
The helmet holder is located under the
seat.
To secure a helmet to the helmet
hol
d er
1. Remove the seat. (See page 3-16.)
2. Hook the helmet onto the helmet
holder, and then securely install
the seat.
WARNING! Never ri d e
with a helmet attache d to the
helmet hol d er, since the helmet
may hit o b jects, causin g loss of
control an d possi b ly an acci-
d ent.
[EWA10162]
To release the helmet from the hel-
met hol
d er
Remove the seat, remove the helmet
from the helmet holder, and then install
the seat.
EAU15306
Si d estan d
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
EWA10242
The vehicle must not b e ri dd en with
the si d estan d d own, or if the si d e-
stan d cannot b e properly move d up
(or d oes not stay up), otherwise the
si d estan d coul d contact the g roun d
an d d istract the operator, resultin g
in a possi b le loss of control.
Yamaha’s i g nition circuit cut-off
system has b een d esi g ne d to assist
the operator in fulfillin g the respon-
si b ility of raisin g the si d estan d b e-
fore startin g off. Therefore, check
1. Helmet holder
ZAUM2033
1
UBFGE0E0.book Page 17 Friday, April 9, 2021 9:25 AM