Instrument an
d
control functions
5-10
5
In this case, push the select switch to
switch the display in the following or-
der:
F-TRIP
Display–1
Display–2
Display–3
F-TRIP
If you do not reset the fuel reserve trip-
meter manually, it will reset automati-
cally after refueling and traveling 5 km
(3 mi).
TIP
You cannot enter setting mode (page
5-11) while “F-TRIP” is on.
Estimated traveling range:
The estimated distance that can be
traveled with the remaining fuel under
the current riding conditions is shown.
Ambient temperature:
This shows the ambient temperature
from –9 °C to 50 °C in 1 °C increments.
The temperature displayed may vary
from the actual ambient temperature.
TIP
–9 °C will be displayed even if the
detected temperature is lower.
50 °C will be displayed even if the
detected temperature is higher.
The accuracy of the temperature
reading may be affected when rid-
ing under 20 km/h (12 mi/h) or
when stopped at traffic signals
and railroad crossings.
Average fuel consumption:
The average fuel consumption mode
“F.AVE” can be set to “km/L” or
“L/100km”. For UK-spec vehicles:
“MPG”. (See page 5-14.)
To reset the average fuel consumption,
use the select switch to select the in-
formation display page that contains
the average fuel consumption display.
Push the “
” side of the select switch
so that the average fuel consumption
display flashes, and then push
the “
” side of the select switch again
for 1 second while the display is flash-
ing.
TIP
After resetting the average fuel con-
sumption display, “– –.–” will be shown
until the vehicle has traveled 1 km (0.6
mi).
NOTICE
ECA15474
If there is a malfunction, “– –.–” will
b
e continuously
d
isplaye
d
. Have a
Yamaha
d
ealer check the vehicle.
UB3TE0E0.book Page 10 Tuesday, September 17, 2019 9:35 AM
