Yamaha XLT1200 WaveRunner 2002, Owner'S/Operator'S Manual

Page: 79 / 142

3-18
E
5. If the “LOCK” mode was chosen previ-
ously, choose the “START” mode before
starting the engine. (See pages 2-22 to
2-23 for selecting “PADLOC” mode.)
NOTE:
@
● If the initial setting of the PADLOC has not
been done, the “START” mode is auto-
matically selected.
● If you have previously chosen “LOCK”
mode, the engine will not start unless the
correct code is entered. This selects the
“START” mode.
@
6. While lightly squeezing the throttle lever,
push the start switch (green button).
WARNING
@
On this watercraft, the engine is con-
nected directly to the jet pump. Starting
the engine immediately generates some
thrust. Apply only enough throttle to
keep the engine running.
@
7. Release the start switch as soon as the
engine starts to run.
CAUTION:
@
● Never push the start switch while the
engine is running.
● Do not operate the start switch for
more than 5 seconds, otherwise the
battery will be discharged and the
engine will not start. Also, the starter
motor may be damaged. If the engine
does not start in 5 seconds, release
the start switch, wait 15 seconds, and
try again.
@
8. After the engine has warmed up, push
the choke knob in to its original position.
NOTE:
@
If the choke knob is left pulled out, the
engine will stall.
@
UF0V11.book Page 18 Monday, July 9, 2001 2:01 PM