Instrument an
d
control functions
6-34
6
3. Remove the power outlet cap.
4. Turn the accessory off.
5. Insert the accessory plug into the
power outlet.
6. Turn the main switch on, and then
start the engine. (See page 8-2.)
7. Turn the accessory on.
EAUN4190
DC connectors
This vehicle is equipped with additional
wiring and DC connector(s) for the in-
stallation of optional grip warmers.
Consult a Yamaha dealer for more in-
formation regarding the location and
capacity of the DC connector(s) and
about what accessories are capable of
being installed.
EAU15306
Si
d
estan
d
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
EWA10242
The vehicle must not
b
e ri
dd
en with
the si
d
estan
d
d
own, or if the si
d
e-
stan
d
cannot
b
e properly move
d
up
(or
d
oes not stay up), otherwise the
si
d
estan
d
coul
d
contact the
g
roun
d
an
d
d
istract the operator, resultin
g
in a possi
b
le loss of control.
Yamaha’s i
g
nition circuit cut-off
system has
b
een
d
esi
g
ne
d
to assist
the operator in fulfillin
g
the respon-
si
b
ility of raisin
g
the si
d
estan
d
b
e-
fore startin
g
off. Therefore, check
1. Power outlet cap
1. Power outlet
1
1
UBKA10E0.book Page 34 Thursday, September 22, 2022 1:40 PM
