Periodic maintenance and adjustment
7-40
1
2
3
4
5
6
7
8
9
10
11
12
installing the spacers, be sure
to install them on the correct
side.
[ECA17701]
2. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the wheel.
3. Insert the wheel axle from the right
side.
4. Install the axle nut.
5. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
6. Tighten the axle nut, and then the
front wheel axle pinch bolts to the
specified torques.
7. Push down hard on the handlebar
several times to check for proper
fork operation.
EAU25081
Rear wheel
EAU56693
To remove the rear wheel
WARNING
EWA10822
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
2. Lift the rear wheel off the ground
according to the procedure on
page 7-39.
3. Remove the axle nut and washer.
4. Loosen the locknut on each side of
the swingarm.
5. Turn the drive chain slack adjust-
ing bolts fully in direction (a).
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
TIP
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
7. While supporting the brake caliper,
pull the wheel axle out.
Tightening torques:
Axle nut:
63 N·m (6.3 kgf·m, 47 lb·ft)
Front wheel axle pinch bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
1. Axle nut
2. Washer
1
2
1. Drive chain slack adjusting bolt
2. Locknut
3. Brake caliper
1
2
3
(a)
2CF-9-17_E0.book 40 ページ ２０１９年５月３０日 木曜日 午前１０時３６分
