Yamaha WaveRunner FX Cruiser SHO, Service Manual

Page: 337 / 433

E
ELEC
– +
1
2
3
4
5
6
7
8
9
7-60
2. Push the lock button
5
or unlock button
6
to transmit the ID code from the remote
control transmitter to be registered.
NOTE:
• At this time, the system enters the registra-
tion mode to register the first code. All exist-
ing ID codes will be deleted from the remote
control receiver.
• The “ UNLOCK ” indicator light 7 blinks when
the registration of the ID code has been com-
pleted. (If the registration could not be com-
pleted, the
“ UNLOCK ” indicator light comes
on. Re-transmit the ID code.)
3. After confirming that the registration of the
ID code has been completed using the
“ UNLOCK ” indicator light 7 , transmit the
next ID code.
NOTE:
• Up to 5 remote control transmitters can be
registered in any sequence, regardless of
whether they are original equipment or addi-
tional transmitters.
• The same ID code cannot be registered
twice in the remote control receiver.
4. After ID code registration has been com-
pleted, disconnect the entry box to exit the
registration mode.
Remote control transmitter
1. Check:
• Remote control transmitter operation
Does not operate
→
Measure the
remote control transmitter battery volt-
age or check the remote control
receiver.
5 6
7
Remote control system