Yamaha V50, Authorized Product Manual

Page: 30 / 161

If assign mode has been set to DVA
The upper line will show the voice of the instrument
where the cursor is located.
Function
Set the number of reserved notes for each instrument.
Settings
off, 0 – 16 (total of all instruments must not be greater
than 16) "off" indicates that the instrument is not
used. “0” indicates that 0 notes are reserved.)
Explanation
When more than 16 keys are being pressed, these
settings determine the minimum number of notes
reserved (i.e., guaranteed) for each instrument.
Voice number
Press (VOICE NUMBER). The upper line of the
display will show the receive channel and voice of the
instrument where the cursor is located.
Function
Select the voice to be used by each instrument.
Settings
I00 – I99, P00 – P99, C00 – C99
Explanation
This selects the voice to be used by each instrument.
Note:
A
voice number cannot be selected for an instrument
whose maximum note setting is 0 (or when DVA is
used, whose reserved note setting is “off”).
Also, card voices cannot be used in an internal
performance. Internal performances can use only
preset voices and internal voices. In the same way,
card performances cannot use internal voices. Card
performances can use only preset voices and card
voices.
Receive channel
Press (RECV CH). The upper line of the display
will show the keyboard transmit channel, and the voice
of the instrument where the cursor is located.
Function
Set the MIDI channel received by each instrument.
Settings
1-16, omn
Explanation
Each instrument will sound only when data arrives
on the channel specified here. When “omn” is selected,
the instrument will sound in response to data arriving
on any channel.
Normally, the V50 keyboard transmits on channel
1. When creating a performance to be played from
the V50 keyboard (not from the sequencer or an ex-
ternal keyboard), be sure to set the receive channel
of all instruments to 1 or “omn” (omni). (It is possible
to change the V50 keyboard transmit channel.)
When using the sequencer, make sure that the
receive channel of each instrument matches the
transmit channel of each track of the sequencer.
Note:
A receive channel cannot be set for instruments whose
maximum note setting is 0 (or when DVA is used
whose reserved note setting is "off").
If assign mode is set to alternate assign, only the
receive channel of instrument 1 will be used.
Note limit (low)
Press (LIMIT/LOW). The upper line of the
display will show the note limit (high) setting and voice
of the instrument where the cursor is located.
Function
Set the keyboard playing range (lower limit) of each
instrument.
Settings
C-2 – G8
Performance Edit
25