UW10 Owner’s Manua
l
29
English
Specifications
Audio Capability:
One stereo-line recording
One stereo-line playback
Sampling Frequencies
Input:32 kHz, 44.1 kHz, 48 kHz
Output:32 kHz, 44.1 kHz, 48 kHz
Jacks and connectors:
Digital in jack (optical)
Digital out jack (optical)
Line in jacks (RCA pin, L/R)
Line out jacks (RCA pin, L/R)
USB connector
Headphone jack (stereo mini)
Power Supply:
USB bus power supply
Dimensions:
111(W)
×
×
×
×
65(D)
×
×
×
×
31(H) [mm]
Weight:
95g
Option:
Optical digital cable (with optical plugs)
Specifications and descriptions in this Owner’s Manual are provided for
information purposes only. Yamaha Corporation reserves the right to change or
modify products or specifications at any time without prior notice. Since
specifications, equipment or options may not be the same in every locale, please
check with your Yamaha dealer.
Troubleshooting (FAQ)
●
The driver cannot be installed.
•
Is the USB cable connected correctly?
→
Check the USB cable connection. (page 13)
→
Disconnect the USB cable, then re-connect it.
•
Is the USB function enabled on your computer?
→
When you connect the UW10 to the computer for the first time, if the “Add New
Hardware Wizard” (page 16) does not appear, the USB function on the computer
may be disabled. Perform the following steps.
1. Select [Control Panel | System | (Hardware) | Device Manager].
2. Make sure that “Universal Serial Bus Controller” and “USB Route Hub” are
not marked with “!” or “x.” If one of these items is marked with “!” or “x,”
you cannot use USB connections. For more information, refer to the docu-
mentation that came with your computer.
27
