Yamaha UD-Stomp, User Manual

Page: 19 / 32

19
Selecting and Saving Patches
■
Try Selecting Another Patch
The UD-Stomp holds a total of 180 patch programs
(patch) in its internal memory.
The 180 patches are divided into two areas each
containing 10 groups, 3 banks and 3 patches.
• AREA
There are two areas, the USER AREA and the
PRESET AREA . When the Store operation is
used, data in the USER AREA (90 patches) can
be freely rewritten. You can change settings in
the PRESET AREA (90 patches) data but you
can not rewrite the contents to the PRESET
AREA memory.
When a PRESET AREA patch is selected, a dot
will appear to the lower right of the hundred’s
digit on the display (
0.11
-
9.33
) When the dot
is not lit (
011
-
933
), it indicates that a patch in
the USER AREA is selected.
* When the UD-Stomp is shipped from the factory, the same
patch data as found in the PRESET AREA is used in the
USER AREA. Refer to the [Patch List] on the separate
“Patch List” sheet.
• GROUP
The 90 patches in each area are divided into 10
groups (0-9).
• BANK
Each group is divided into 3 banks (1-3).
• PATCH
Each bank contains 3 patches (1-3).
Try selecting some of the different patches and try
out some of the different sounds.
To select a different patch, use one of the three
methods described below.
●
Using the [UP]/[DOWN] buttons on the
panel
• Each time the [UP] button is pressed, the next
greater patch number is selected.
011 → 012 → 013 → 021 → 022 →
023
..
033 → 111
.....
933 → 0.11 →
0.12
.....
9.33 → 011
(returns to the top)...
Every time the [DOWN] button is pressed, the
next lower
patch number is selected.
• Press the [UP] button continuously increases the
group number by one (1).
011
→
111
→
211
.....
911
→
0.11
→
1.11
→
2.11
.....
9.11
→
011
(returns to
the top)...
Press the [DOWN] button continuously de-
creases the
group number by one (1).
• Press the [UP] and [DOWN] button simulta-
neously to switch between the USER AREA
↔
PRESET AREA .
011
↔
0.11
• Patch Characteristics