111
Tyros4
SYSTEM BOOTING FLOWCHART
Instrument ID
writing mode
Test mode
CPU registers setting
Port initialization
Initialize Enhancing port
Initialize BOOT SDRAM
0 clear,
Setup of Constant
E-BUS driver
initialization
Send a message to
SWP51L (IC700, 701)
If the booting procedure does not
reach to this stage, the following
parts might be defective:
Backlight ON
BRT = H
Installation mode?
Screen will brighten
If there is the updater,
the system will shift
to installation mode.
* “After executing Factory Set” refers to the condition when the power is turned
on after executing “Factory Set” in the Test Program.
Is Main Program
defective?
Installation
failure, etc.
Installer program
not found!
Peripheral Reset
/LAN-RES = L
/DAC-IC = L
/MIDI-IC = L
/USB-RES = L
/SWP-IC = L
/AVDP-RES = L
Since set the "L" other than
SWP-IC, it can not recognize the
SWP-IC decay.
Transmit Main Program
to SDRAM
Send to SDRAM
(IC201/202/203/204)
When there is no
media containing
the updater.
MAC Address
Writing Mode?
MAC Address
written?
Test Program?
After executing
Factory Set (*)
Failure in writing at
the time of production
A
Installation
Installation
END
/PRG-WP = L (IC16 16pin)
/BACKUP-WP = L (IC23 16pin)
/MUTE = L (IC959 5pin)
/SPOFF = L (IC959 3pin)
NTSC/PAL = L (IC606 7pin)
BRT = L (CN302 1pin)
/LAN-RES = L (IC14 16pin)
/DAC-IC = L (IC14 15pin)
/MIDI-IC = L (IC14 12pin)
/USB-RES = L (IC14 9pin)
/SWP-IC = L (IC14 5pin)
/AVDP-RES = L (IC14 2pin)
/SWP-RES = H
SSP1 soft reset
IC902
Opening screen
will appear
• CPU (IC1)
• SWP51L (IC701)
If the booting procedure does not
reach to this stage, the following
parts might be defective:
• SDRAM
Initialize SDRAM
(It takes about several
hundreds milliseconds.)
Release peripheral reset
/LAN-RES = H
/DAC-IC = H
/MIDI-IC = H
/USB-RES = H
/SWP-IC = H
/AVDP-RES = H
Summary of Contents for Tyros4
