6-23
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
1
6. Insert a new cotter pin into the
axle nut and bend the end of
the cotter pin as shown in the
illustration. If the notch in the
nut and cotter pin hole do not
match, tighten the nut slightly
to align them.
EW000110
w
Always use a new cotter pin on
the axle nut.
1.
Cotter pin
7. Adjust the free play in the
brake pedal. (See page 6-19.)
EW000103
w
Check the operation of the brake
light after adjusting the rear brake.
EAU01106
Drive chain lubrication
The chain consists of many parts
which work with each other. If the
chain is not maintained properly, it
will wear out quickly. Therefore,
the chain must be serviced regular-
ly. This service is especially neces-
sary when riding in dusty areas.
1. The drive chain should be
lubricated every 500 km. First,
remove all dirt and mud from
the chain with a brush or cloth.
Then, spray any of the many
brands of spray-type chain
lubricant between both rows
of side plates and on all center
rollers.
2. To clean the chain thoroughly,
remove it from the motorcycle,
dip it in solvent, and clean out
as much dirt as possible. Then,
take the chain out of the sol-
vent to dry it, and immediately
lubricate it to prevent it from
rusting.
3XT-9-29-6 (AUS) 4/12/0 5:33 AM Page 23
