Motorcycle care an
d
stora
g
e
8-4
8
EAU84141
Stora
g
e
Always store the vehicle in a cool, dry
place. If necessary, protect it against
dust with a porous cover. Be sure the
engine and the exhaust system are
cool before covering the vehicle. If the
vehicle often sits for weeks at a time
between uses, the use of a quality fuel
stabilizer (Fuel Med RX) is recommend-
ed after each fill-up.
NOTICE
ECA21170
Storin
g
the vehicle in a poorly
ventilate
d
room or coverin
g
it
with a tarp, while it is still wet,
will allow water an
d
humi
d
ity to
seep in an
d
cause rust.
To prevent corrosion, avoi
d
d
amp cellars, sta
b
les (
b
ecause
of the presence of ammonia)
an
d
areas where stron
g
chemi-
cals are store
d
.
Lon
g
term stora
g
e
Before storing the vehicle long term (60
days or more):
1. Make all necessary repairs and
perform any outstanding mainte-
nance.
2. Follow all instructions in the Care
section of this chapter.
3. Fill up the fuel tank, adding fuel
stabilizer according to product in-
structions. Run the engine for 5
minutes to distribute treated fuel
through the fuel system.
4. For vehicles equipped with a fuel
cock: Turn the fuel cock lever to
the off position.
5. For vehicles with a carburetor: To
prevent fuel deposits from build-
ing up, drain the fuel in the carbu-
retor float chamber into a clean
container. Retighten the drain bolt
and pour the fuel back into the fuel
tank.
6. Use a quality engine fogging oil
(YAMALUBE Stor-Rite Engine
Fogging Oil) according to product
instructions to protect internal en-
gine components from corrosion.
If engine fogging oil is not avail-
able, perform the following steps
for each cylinder:
a. Remove the spark plug cap
and spark plug.
b. Pour a teaspoonful of engine
oil into the spark plug bore.
c. Install the spark plug cap onto
the spark plug, and then place
the spark plug on the cylinder
head so that the electrodes are
grounded. (This will limit spark-
ing during the next step.)
d. Turn the engine over several
times with the starter. (This will
coat the cylinder wall with oil.)
WARNING! To prevent
d
am-
a
g
e or injury from sparkin
g
,
make sure to
g
roun
d
the
spark plu
g
electro
d
es while
turnin
g
the en
g
ine over.
[EWA10952]
e. Remove the spark plug cap
from the spark plug, and then
install the spark plug and the
spark plug cap.
7. Lubricate all control cables, piv-
ots, levers and pedals, as well as
the sidestand and centerstand (if
equipped).
UBMB10E0.book Page 4 Monday, August 22, 2022 1:08 PM
