Perio
d
ic maintenance an
d
a
d
justment
7-26
7
TIP
Using the alignment marks on each
side of the swingarm, make sure that
both drive chain pullers are in the same
position for proper wheel alignment.
3. Tighten the axle nut, then the lock-
nuts to their specified torques.
4. Make sure that the drive chain
pullers are in the same position,
the drive chain slack is correct,
and the drive chain moves
smoothly.
EAU23027
Cleanin
g
an
d
lu
b
ricatin
g
the
d
rive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
ECA10584
The
d
rive chain must
b
e lu
b
ricate
d
after washin
g
the motorcycle, ri
d
in
g
in the rain or ri
d
in
g
in wet areas.
1. Clean the drive chain with a drive
chain cleaner and a small soft
brush.
NOTICE:
To prevent
d
am-
a
g
in
g
the O-rin
g
s,
d
o not clean
the
d
rive chain with steam
cleaners, hi
g
h-pressure wash-
ers or inappropriate solvents.
[ECA11122]
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant.
NOTICE:
Do not use
en
g
ine oil or any other lu
b
ri-
1. Drive chain slack adjusting bolt
1. Drive chain puller
2. Position indicator
3. Alignment marks
1
(b)
(a)
2
3
1
Ti
g
htenin
g
torques:
Axle nut:
105 N·m (10.5 kgf·m, 77 lb·ft)
Locknut:
16 N·m (1.6 kgf·m, 12 lb·ft)
UBMB10E0.book Page 26 Monday, August 22, 2022 1:08 PM
