Instrument an
d
control functions
4-24
4
EAUM4130
Front fen
d
er
To suit the riding conditions, the front
fender height can be adjusted.
To a
d
just the front fen
d
er hei
g
ht
1. Loosen the bolts on each side of
the front fender.
2. Move the front fender to the de-
sired height.
3. Tighten the bolts to the specified
torque.
EAU93980
DC power outlets
This vehicle is equipped with an power
outlet, and auxiliary DC connector, a
grip warmer connector and a fog lamp
DC connector.
NOTICE
ECA26810
Do not use any sin
g
le electrical ac-
cessory or com
b
ination of accesso-
ries that require more than the
state
d
capacity at any one time. This
may overloa
d
the circuit an
d
cause
the fuse to
b
low.
TIP
To prevent battery drain, do not use an
accessory with the engine off.
Power outlet
A 12-V accessory with the proper con-
nector can be used when the main
switch is on.
To use the power outlet
1. Turn the vehicle power off.
2. Remove the power outlet cap.
3. Turn the accessory off.
4. Insert the accessory plug into the
power outlet.
1. Bolt
Ti
g
htenin
g
torque:
Front fender bolt:
8 N·m (0.8 kgf·m, 5.9 lb·ft)
1
DC power outlet circuit capacities:
Power outlet and DC connector cir-
cuit:
24 W (2 A)
Grip warmer and Fog lamp circuit:
120 W (10 A)
1. Power outlet cap
1
UBHL10E0.book Page 24 Tuesday, October 5, 2021 9:57 AM
