Yamaha Tenere 700 2020, Service Manual

Page: 461 / 472

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
9-8
EAS32425
DIAGNOSTIC CODE: SENSOR OPERATION TABLE
Diagnostic
code No.
Item Tool display Procedure
01 Throttle position sensor sig-
nal
• Fully closed position 11–21 Check with throttle valves
fully closed.
• Fully open position 96–106 Check with throttle valves
fully open.
03 Intake air pressure Displays the intake air pres-
sure. Operate the throttle while
pushing the start switch. (If
the display value changes,
the performance is OK.)
05 Intake air temperature Displays the air temperature. Compare the actually mea-
sured air temperature with
the tool display value.
06 Coolant temperature When engine is cold: Dis-
plays temperature closer to
air temperature.
When engine is hot: Displays
current coolant temperature. Compare the actually mea-
sured coolant temperature
with the tool display value.
07 Front wheel vehicle speed
pulses Front wheel speed pulse
0–999 Check that the number in-
creases when the front
wheel is rotated. The num-
ber is cumulative and does
not reset each time the
wheel is stopped.
08 Lean angle sensor Lean angle sensor output
voltage Remove the lean angle sen-
sor and incline it more than
65 degrees.
• Upright 0.4–1.4
• Overturned 3.7–4.4
09 Fuel system voltage
(battery voltage) Approximately 12.0 Set the engine stop switch to
“
”, and then compare the
actually measured battery
voltage with the tool display
value. (If the actually mea-
sured battery voltage is low,
recharge the battery.)
20 Sidestand switch Extend and retract the side-
stand (with the transmission
in gear).
• Stand retracted ON
• Stand extended OFF