CAMSHAFTS
5-19
8. Turn:
• Crankshaft
(several turns counterclockwise)
9. Check:
• Mark “a”
Make sure the mark “a” on the generator rotor
is aligned with the slot “b” in the generator ro-
tor cover.
• Camshaft sprocket match mark
Make sure the match marks “c” on the cam-
shaft sprockets are aligned with the cylinder
head mating surface “d”.
Out of alignment
→
Adjust.
Refer to the installation steps above.
10.Measure:
• Valve clearance
Out of specification
→
Adjust.
Refer to “ADJUSTING THE VALVE CLEAR-
ANCE” on page 3-6.
11.Install:
• Timing mark accessing bolt “1”
• Crankshaft end cover “2”
EAS30274
INSTALLING THE CYLINDER HEAD COVER
1. Install:
• Timing chain guide (top side)
• Cylinder head cover gasket “1”
(to the cylinder head cover)
• Cylinder head cover “2”
TIP
• Apply Yamaha bond No.1215 “3” onto the mat-
ing surfaces of the cylinder head cover gasket
and cylinder head.
• After installing the cylinder head cover gasket
“1” to the cylinder head cover, cut off the “a”
section.
• Make sure that the projection “b” on the cylin-
der head cover gasket is positioned on the ex-
haust side of the rib “c” on the cylinder head
cover.
T
R
.
.
Timing mark accessing bolt
15 N·m (1.5 kgf·m, 11 lb·ft)
T
R
.
.
Crankshaft end cover
10 N·m (1.0 kgf·m, 7.4 lb·ft)
b
a
c
d
c
c
T
R
.
.
Cylinder head cover bolt
10 N·m (1.0 kgf·m, 7.4 lb·ft)
Yamaha bond No. 1215
90890-85505
(Three bond No.1215®)
2
1
New
3
3
2
1
a
New
Summary of Contents for Tenere 700 2020
