Yamaha SX230 High output, Owner'S/Operator'S Manual

Page: 55 / 112

3-11
3-10
BIMINI TOP
Raising from the fully collapsed stor-
age position.
1) With an assistant, raise the top and
secure the rear support poles to the
rear support pole mounts with the
lock pins.
2) Unzip and remove the storage
cover.
3) Unfold the top by pulling to the bow
of the Sport Boat.
4) Attach the snap hooks to the strap
eyes.
5) The top should be snug and wrinkle
free. If the top is too loose or too
tight, adjust the front straps by slid-
ing the buckle up or down the strap
as needed.
Do not exceed 45 mph (72 km/h)
with the bimini top in the up posi-
tion.
Horn
Press the horn switch
1
to be sure the
horn operates.
Engine Shut-Off Switch
➀
Engine shut-off switch
➁
Clip with cord
First, place the boat in the water to pro-
vide adequate engine cooling. Start the
engine, and then remove the engine
shut-off switch clip, and verify that the
engine stops.
Refer to pages 3-13 to 3-15, “START-
ING THE ENGINES,” for information on
proper operation of the starter switch.
Cooling-Water Pilot Outlets
Check that water comes out from the
pilot outlets while engine is running in
the water. Refer to page 2-10 for cor-
rect operation of the device.
NOTE: It may take up to 20 seconds
for water to reach the pilot outlets when
first launching the boat. The amount
and force of the exiting water will vary
with engine rpm.
A continuous flow of water from the
pilot hole shows that water is flow-
ing through the engine cooling pas-
sages. If water is not flowing out of
the pilot hole during operation, do
not continue to run the engines.
Overheating and serious damage
could occur. See Overheat Warning
System, page 2-10, for more infor-
mation.
3
O
PERATION
O
PERATION
3
CAUTION:
CAUTION:
1
1
2
*SX230(SRT1000)-'04-OwnMnl 9/17/03 3:06 PM Page 3-10