Yamaha SUV1200 WaveRunner 2004, Owner'S/Operator'S Manual, Page: 100 / 140

4-3
E
EJU11570
Lubrication
WARNING
@
To reduce the risk of fire or explosion:
Never pour or spray gasoline, or any sub-
stance other than engine fogging oil
through the holes in the carburetor
silencer cover.
@
CAUTION:
@
●
Be sure to replace the caps securely
after fogging the engine. Otherwise
water could enter the engine and
cause damage.
● Do not attempt to run the engine at full
throttle or for more than 15 seconds
while the watercraft is out of the water,
otherwise the engine may overheat
and/or seize.
@
1. Open the silencer caps
1
on the
silencer.
2. Start the engine with the watercraft in a
well-ventilated area.
3. With the engine running at a fast idle,
quickly spray as much fogging oil as pos-
sible through the holes in the silencer
cover. Use Yamaha Stor-Rite Fogging Oil
or an equivalent. Keep spraying until the
engine stalls (or a maximum of 15 sec-
onds).
4. Install the caps securely.
5. Lubricate all cables such as the throttle,
choke, and steering cables.
NOTE:
@
Use a Yamaha Power Cable Luber and
Yamaha Lube-Zall to pressure lubricate the
cables and purge out any moisture between
the inner and outer cables.
@
6. Lubricate the areas of the watercraft
specified under Lubrication points on
page 4-16.
UGU513.book Page 3 Tuesday, June 10, 2003 12:21 PM