2
En
■
ASSEMBLY
Before beginning assembly, check the parts list and make
sure all the parts are included.
You need a screwdriver for the assembly.
•
Parts list (for 2 units)
Attaching the spikes
When setting up this unit on a thick carpet etc., attach
spikes on the bottom side of the base in order to increase
stability of this unit and to enhance sound quality.
•
Attaching procedures
1.
For each spike, screw a nut to the tip of the spike.
2.
Screw the spike into the hole of the bottom side of
the base.
3.
Place the base with the topside up in the desired
location and adjust the length of the spike to match
the depth of the carpet.
The tip of the spike may scratch or damage the flooring.
Please be careful when positioning the stand.
•
Assembly procedures
Do not overtighten the screws. Doing so may damage screws or
screw holes.
1. Attach the base and the support.
Align holes in the base with holes in the support,
and then fasten
1
flat-head Phillips screws using a
screwdriver.
2. Attach the plate and the support.
Align holes in the plate with holes in the support,
and then fasten
2
flat-head Phillips screws using a
screwdriver.
When attaching the plate, put the plate with the spacer-side up on
the support.
3. Attach a speaker.
Align holes on the bottom of the speaker with holes
in the plate, and then fasten
3
speaker mounting
screws using a screwdriver.
The screw hole(s) which is (are) used varies (vary) depending on
the speaker. For details about the screw hole(s) which is (are)
used, refer to “USABLE SPEAKERS” on page 1.
4. Fix speaker cables.
Put
4
cable clamps into the conduit to fix speaker
cables after setting speaker cables into the conduit
on the back of the support.
NAME
QUANTITY
1
Flat-head Phillips screws (M6 x 40 mm (1-9/16”))
6
2
Flat-head Phillips screws (M6 x 20 mm (13/16”))
6
3
Speaker mounting screws (M4 x 14 mm (9/16”))
4
4
Cable clamps
8
5
Spikes 8
6
Nuts 8
1
3
2
4
Example:
Soavo-2
Speaker
cable
Plate
Spacer
Support
Base
Assembly figure
Note
Note
Note
Note
6
5
1
2
Bottom side of the base
