Yamaha SP2060, Service Manual

Page: 63 / 123

SP2060
63
4-1-2 DME Designer software also enables you to update the Program.
Refer to the DME Designer Owner’s Manual for details.
Note
You can not update the Boot via DME Designer software.
To update the Boot, follow the steps in “2. Updating the program and boot”.
4-2. Downloading the Program and Boot
4-2-1 The SP2060 data package includes the program, boot, program update software, boot update software, DME-N
Network Driver and TeraTerm.
Downloading the SP2060 data package from the YSISS homepage is recommended to download the program
and latest boot.
(URL >> http://plaza.yamaha.co.jp/ysiss/exindex.nsf)
4-2-2 You can download the latest program from the following Yamaha website.
http://www.yamahaproaudio.com/
Note
In this way, you can not download the latest boot.
When you need the latest boot, download the SP2060 data package from the YSISS homepage.
5. Updating the Component data
After updating the program or boot, be sure to update the component data, or the error message may be displayed when
initializing such as FACTORY PRESET.
5-1. Operation
1 While pressing the [SEL5] and [SEL6] keys, turn on the power to the SP2060.
Keep pressing the [SEL5] and [SEL6] keys until “Copyright 2006 YAMAHA” disappears from the display of SP2060.
2 Double click on “sync.exe” of C: ￥ TOOLS_SP2060 ￥ tools ￥ sync ￥ component ￥ .
Then the update software is activated and the setting and executing screen is displayed.
3 Set the parameters on the screen according to the following parameters.
Output Port : ZONE1
Input Port : ZONE1
target ID : 2
Firmware : Select C: ￥ TOOL_SP2060 ￥ component ￥ SP2060.dat
4 Click on “Synchronize...” button to start update.
The updating will be completed in about 90 seconds.
Note
Never turn off the power to the SP 2060 until the updating is completed.
5-2. Confirming the version of written component data
1
Once be sure to turn off the power to the SP 2060.
2 Follow the steps 1 to 3 of “5-1. Operation”.
3
Click on “Check...” button.
When “Vx.xx” is displayed at “component group version”, the updating component data is successful.
Confirm the “Vx.xx” is the same as the program version.
When “Error!!” is displayed at “component group version”, the updating component data is unsuccessful.
In this case, follow the steps 1 to 4 of “5-1. Operation” again.
And also, follow the steps
1
to
3
of “5-2. Confirming the version of written component data” again.