8
Installation based on an engine version Yamaha PW:
Required tools:
•
3 mm allen key
•
6 mm allen key
•
small screwdriver
Unscrew the three 3 mm allen screws (Fig. 9). It is possible that these are provided with a screw-locking
device. In this case, heat the screws first.
Remove the two 6 mm allen screws 1 and 2 (Fig. 10). Unscrew the third 6 mm allen screw (Fig. 11) as
far as possible until the motor can be swung out of the frame (Fig. 12). Now you can see the plug
connections. Disconnect the connector of the speed sensor by pressing the detent with the small
screwdriver.
Now close the sIMPLEk between motor and speed sensor. Ensure that the connectors are correctly
seated (audible clicking noise when snapping into place).
Then the motor can be fixed in the frame again and all screws can be installed.
Lay the USB connection cable with the supplied cable ties to the desired position of the sIMPLEk stick.
figure 09
figure 10
figure 11
figure 12
