9
■
Attaching the Frame Unit
The SILENT Bass™ is shipped from the factory with the Frame Unit removed from the
main body.
Please properly attach the Frame Unit using the following procedure.
• Make sure that Fixing Knobs 1-3 are tightened firmly. If they are left loose, it may result in rattle or
noise during performance.
• When transporting the instrument, always hold it by its neck or main body. Holding by the frame unit
only may result in damage to the frame unit.
1
Open the frame unit’s armrest until it comes in contact
with the stopper.
2
Fully loosen the [Fixing Knob 2] located on the bottom
end of the main body.
3
Align the cut end of the Frame Unit with the post
above the [Fixing Knob 2] and fully insert. Then, align
the notch at the top of the Frame Unit so it rests on the
top of the bass’ main body and slowly insert.
4
Turn the [Fixing Knob 1] located on the upper portion
of the frame unit clockwise until it is tight, to attach
the frame unit to the body.
5
Turn the [Fixing Knob 2] on the bottom end of the
main body clockwise (looking from the bottom) until
it is tight, to attach the frame unit to the body.
6
Align the [Fixing Knob 3], located on the center of the
frame unit, with the Fixing Knob Plate located on the
center of the main body, then turn clockwise to tighten.
When you move the frame unit’s
center section, be careful not to
pinch your fingers, hand, etc.
This completes attachment of the frame unit.
To remove the frame, simply reverse the order of the previous procedure.
1
2
3
4
5
Fixing Nut 2
Fixing Knob 1
3
Tighten
6
Fixing Knob 3
Tighten
Tighten
Loosen
002_slb100_en_1204.indd 9
15/01/06 13:27
