Yamaha RX10K, Owner'S Manual

Page: 45 / 105

7-1
ESU00112
7-
OPERATION
ESU00366
Starting the engine
WARNING
@
● Be sure to check the “SAFETY INFORMATION”
section carefully before starting the engine.
● Make sure that the parking brake is applied.
@
NOTE:
@
Make sure that the engine stop switch is in the on posi-
tion. The starter motor cannot be operated when the
engine stop switch is in the off position.
@
1. Fully open the starter lever (choke).
1 Starter lever (choke)
2 Fully open (cold engine starting)
3 Half-open (warm engine up)
4 Closed (warm engine starting)
NOTE:
@
The starter lever (choke) is not required when the engine
is warm. Put the starter lever (choke) in the closed posi-
tion.
@
2. Turn the main switch to the “START” position. After
the engine starts, put the starter lever (choke) in the
half-open position. Warm up the engine until it does
not run roughly or begin to stall when the starter lever
is returned to the closed position.
1 “START”
CAUTION:
@
●
Release the switch immediately after the engine
starts.
● If the engine fails to start, release the switch, wait
a few seconds, then try again. Each attempt
should be as short as possible to preserve the
battery. Do not crank the engine more than 10
seconds on any one attempt.
@
U8FU10.book Page 1 Thursday, April 8, 2004 6:27 PM