31
REMOTE CONTROL TRANSMITTER
Battery installation
1
2
3
Battery replacement
If you find that the remote control transmitter must be
used closer to the main unit, the batteries are weak.
Replace both batteries with new ones.
Notes:
• Use only AA, LR6, UM-3 batteries for replacement.
• Be sure the polarities are correct. (See the illustration
inside the battery compartment.)
• Remove the batteries if the remote control transmitter
will not be used for an extended period of time.
• If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact
with clothing, etc. Clean the battery compartment
thoroughly before installing new batteries.
Remote control transmitter operation range
Remoto control
sensor
30°
30°
Within approximately
7 m (23 feet)
Notes:
• There should be no large obstacles between the remote
control transmitter and the main unit.
• If the remote control sensor is directly illuminated by
strong lighting (especially an inverter type of fluorescent
lamp etc.), it might cause the remote control transmitter
not to work correctly. In this case, reposition the main
unit to avoid direct lighting.
STANDBY mode (Singapore model only)
While the power is on, pressing the POWER key on
the remote control transmiter switches the unit to the
STANDBY mode. (In this mode, the indicator is half
illuminated.)
POWER on mode
STANDBY mode
