RX-V3000/RX-V3000RDS
RX-V3000
RX-V3000RDS
1.DSP
THR
8.RS232C
2.HP
ROUTE
9.PRESET
3.RAM
THR
10.AD
DATA
4.PRO
LOGIC
11.STATUS
5.SP
SET
12.DSP
RAM
6.DISP
CHECK
13.VER
SUM
7.MANL
TEST
DIAGNOSTIC
MENU
●
Display at the start of DIAG
The diagnostic menu appears on the monitor screen. (It remains on display until it is canceled.)
On the FL display of the main unit, an opening message (including the version, checksum and the
history of protection function) appears for a few seconds followed by the diagnostic menu display of 1
DSP THROUGH: ANALOG BYPS.
Version (1 alphabet)
Opening message
Version
(Fully indicated)
NO
PROTECT
X
XXXXXXXX
A:XXXX
Checksum
(4 figures consisting of
alphabets and numbers
DIAG menu display
1.
DSP
THROUGH
ANALOG
BYPS
When there is no history
of protection function (*1)
(*1) If the history of the protection function has been recorded, the type of the protection function and
the voltage value recorded last are displayed.
Checksum (4 figures consisting of alphabets and numbers)
The checksum is obtained by adding 4M bits per 16bits of the entire program code and expressing the result as
a 4-figure hexadecimal data. (0xffff is added for the area where no code has been entered and for the area other
than ROM code.)
11
After a few
secounds
