Yamaha RX-V1900BL, Owner'S Manual

Page: 30 / 146

26
En
Connections
1
Make sure this unit is turned off.
2
Press and hold
O
STRAIGHT
on the front
panel and then press
A
MASTER ON/OFF
inward to the ON position.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3
Rotate the
N
PROGRAM
selector to select
“SPEAKER IMP.”.
4
Press
O
STRAIGHT
repeatedly to select
“6
Ω
MIN”.
5
Press
A
MASTER ON/OFF
to release it
outward to the OFF position to save the new
setting and turn off this unit.
The setting you made is reflected next time you turn on this
unit.
■
Turning on this unit
Press
A
MASTER ON/OFF
on the front panel
inward to the ON position.
When you turn on this unit by pressing
A
MASTER ON/
OFF , the main zone is turned on.
■
Turning off this unit
Press
A
MASTER ON/OFF
on the front panel
again to release it outward to the OFF position.
■
Set the main zone to the standby mode
Press
B
MAIN ZONE ON/OFF
(or
C
STANDBY
).
■
Turning on the main zone from the
standby mode
Press
B
MAIN ZONE ON/OFF
(or
D
POWER
).
y
• Basically, we recommend that you use the standby mode to turn
off this unit. In the standby mode, this unit consumes a small
amount of power in order to receive infrared signals from the
remote control.
•
B
MAIN ZONE ON/OFF,
C
STANDBY and
D
POWER are
operational only when
A
MASTER ON/OFF is pressed inward
to the ON position.
• When you turn on this unit, there will be a delay for a few
seconds before this unit can reproduce sound.
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SPEAKER
IMP.” to “6
Ω
MIN” as follows BEFORE using this
unit. You can also use 4 ohm speakers as the front
speakers (page 102).
Note
EFFECT
STRAIGHT
MASTER
While holding
down
Turning this unit on and off
If there are some problems...
• First, turn off and then turn on this unit again.
• If problems persist, initialize the parameters of this
unit (page 115).