En
36
Error messages
If any error message is displayed during the measurement, resolve the problem and perform YPAO again.
Error message
Cause
Remedy
E-1: No Front SP
Front speakers are not detected.
Follow the on-screen instructions to exit YPAO, turn off this unit, and then check the speaker connections.
E-2: No Sur. SP
Either of surround speakers is not detected.
E-3: No F.PRNS SP
Either of presence speakers is not detected.
E-4: SBR
SBL
A surround back speaker is connected to the R side only.
When using only one surround back speaker, you need to connect it to the SINGLE jack (L side). Follow the
on-screen instructions to exit YPAO, turn off this unit, and then reconnect the speaker.
E-5: Noisy
The noise is too loud.
Keep the room quiet and follow the on-screen instructions to start the measurement again. If you select
“PROCEED”, the measurement starts again on the condition this unit ignores the noisy error even if noises
are detected.
E-6: Check Sur.
Any surround back speaker is connected while no surround
speakers are connected.
Surround speakers should be connected when using surround back speakers. Follow the on-screen
instructions to exit YPAO, turn off this unit, and then reconnect the speakers.
E-7: No MIC
The YPAO microphone has been removed.
Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the
measurement again.
E-8: No Signal
The YPAO microphone cannot detect test tones.
Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the
measurement again. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service
center.
E-9: User Cancel
The measurement has been canceled.
Follow the on-screen instructions to start the measurement again. To cancel the measurement, select “EXIT”.
E-10: Internal Error
An internal error has occurred.
Follow the on-screen instructions to exit YPAO, turn off and on this unit. If this error occurs repeatedly,
contact the nearest authorized Yamaha dealer or service center.
1 2 3 4 5 6 7 8 9
Automatic speaker setup
