3
Attach the Drum Pad Clamps
3-1
Insert the Hex Rod Cylinder
into the Drum Pad Clamp
,
and tighten the fixing bolt.
3-2
Attach the Drum Pad Clamps
to the tom tom and hi-hat lo-
cations.
3-3
Insert the Hex Rod Cylinder
into the Pads, adjust the angle
and secure.
4
1
Attach the Center Pipe Assembly
to the Left Side Assembly
and the Right Side Assembly
, and tighten the fixing bolts.
2
Module Holder
DTXP
Hex Rod Cylinder
Attach the Module Holder Clamp
Left Side Assembly
Attach the Center Pipe
Right Side Assembly
Cymbal Holder
Drum Pad Clamp
Hex Rod Cylinder
■
RS60 Assembly
* A screw driver (+ or -) is necessary to complete the assembly.
• Over-tightening of the fixing bolts may result in damage. Take care when tightening fixing bolts and screws.
• When attaching the pads and the DTXPRESS to the rack, make sure their weight is not extremely unbalanced. Also, take into consideration
the forces that are applied while playing the RS60 so that it can be played in a stable condition without excessive deflection.
Step
4-2
Step
3-1
Step
4-1
Step
2-1
Step
2-2
Step
2-3
Step
2-4
Step
3-3
Step
3-2
Cymbal Pad
Tighten
Tighten
Tighten
Tighten
After the above assembly is complete, set the Kick Pad, Hi-Hat Con-
trol Pedal, etc. into position and connect the necessary cables. To
keep cable out of the way while playing, use the supplied Cable Bands
to hold the cables to the rack systems’s pipes.
Drum Pad Clamp
Cymbal Holder
Left Side Assembly
Attach the Module Holder
2-1
Insert the Hex Rod Cylinder
into the Module Holder Clamp
, and tighten the fixing bolts.
2-2
Attach the Module Holder Clamp
to the Left Side Assembly
pipe.
2-3
Attach the DTXPRESS to the Module Holder
. With a screw-
driver, use the screws included with the Module Holder to at-
tach the holder to the bottom of the DTXPRESS.
2-4
Attach the Module Holder
(with the DTXPRESS attached)
to the Module Holder Clamp
.
Attach the Cymbal Holders
4-1
Insert the Cymbal Holders
into the Cymbal Holder Clamps
that are attach to the left and right sides of the Center Pipe
,
and tighten all fixing bolts.
4-2
Attach the Cymbal Pad to the Cymbal Holders
, adjust the
position and tighten the fixing bolts. (Refer to the Cymbal Pad’s
Owner’s Manual for instructions on attaching the cymbal pad to
the cymbal holder.)
