Yamaha Rhino 450 YXR45FAV, Service Manual

Page: 252 / 413

7 - 11
DRIV
FRONT CONSTANT VELOCITY JOINTS, DIFFERENTIAL
GEAR AND FRONT DRIVE SHAFT
3. Check:
• front drive shaft
Bends
→
Replace.
• torque limiter 1
Loose
→
Replace the front drive shaft.
WARNING
Do not attempt to straighten a bent shaft;
this may dangerously weaken the shaft.
1
CHECKING THE GEAR MOTOR
1. Check:
• gear motor
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Connect two C size batteries to the gear
motor terminals 1 (as shown in the illustra-
tions).
CAUTION:
• Do not use a 12 V battery to operate the
pinion gear.
• Do not connect the batteries to the gear
motor when it is installed in the gear
case. The gear motor should be checked
when it is removed from the gear case.
È
Check that the pinion gear 2 turns counter-
clockwise.
É
Check that the pinion gear 2 turns clockwise.
NOTE:
Do not disassemble the gear motor.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
È
É
ASSEMBLING THE FRONT CONSTANT
VELOCITY JOINTS
1. Apply:
• molybdenum disulfide grease
(into the ball joint assembly)
NOTE:
Molybdenum disulfide grease is included in the
repair kit.