Yamaha RAPTOR YFM700RF 2015, Service Manual

Page: 49 / 394

TIGHTENING TORQUES
2-20
TIP
1. Apply a rust preventive lubricant to the threads on both sides of the rear axle and to the wheel hub
surfaces that contact the rear axle washers.
2. Tighten the rear axle nuts 200 Nm (20.0 m·kg, 145 ft·lb).
3. Loosen the rear axle nuts completely.
4. Retighten the rear axle nuts 200 Nm (20.0 m·kg, 145 ft·lb). Do not loosen the axle nuts after tighten-
ing them.
If an axle nut slot is not aligned with the cotter pin hole on either side of the axle, further tighten the
axle nut until a slot is aligned with the hole.
Rear brake caliper union bolt M10 1 30 Nm (3 m·kg, 22 ft·lb)
Parking brake case bolt M8 2 22 Nm (2.2 m·kg, 16 ft·lb)
Rear brake master bolt M6 2 20 Nm (2 m·kg, 14 ft·lb)
Rear brake master cylinder union
bolt
M10 1 30 Nm (3 m·kg, 22 ft·lb)
Rear brake master cylinder ad-
justing bolt
M8 1 17 Nm (1.7 m·kg, 12 ft·lb)
Parking brake adjusting bolt lock-
nut
M6 1 16 Nm (1.6 m·kg, 11 ft·lb)
Rear brake disc mounting bolt M8 4 33 Nm (3.3 m·kg, 24 ft·lb)
Brake hose holder bolt M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
Front guard bolt M8 4 12 Nm (1.2 m·kg, 8.7 ft·lb)
Front panel bolt M6 2 4 Nm (0.4 m·kg, 2.9 ft·lb)
Front fender bolt M6 3 7 Nm (0.7 m·kg, 5.1 ft·lb)
Front fender nut M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
Headlight bolt M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
Rear fender bolt M6 1 7 Nm (0.7 m·kg, 5.1 ft·lb)
Rear fender bolt M6 2 9 Nm (0.7 m·kg, 5.1 ft·lb)
Rear fender nut M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
Tail/brake light assembly bolt M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
Battery holding bracket bolt M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
Air filter case bolt M6 4 7 Nm (0.7 m·kg, 5.1 ft·lb)
Rear carrier bar bolt M8 4 32 Nm (3.2 m·kg, 23 ft·lb)
ECU bolt M6 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
Lean angle sensor nut M4 2 2 Nm (0.2 m·kg, 1.4 ft·lb)
Item
Thread
size
Q’ty Tightening torque Remarks
LT
LT
LT