Maintenance screen
Reference Manual
TF Series
- 78 -
Maintenance screen
Allows you to access maintenance features.
1
Displays the Initialize All Memory screen.
2
Displays the Initialize Current Memory screen. (
)
3
Displays the Initialize NY64-D screen. (
) (V3.0 and later)
4
Displays the Input Port Trim screen. (
5
Displays the Output Port Trim screen. (
)
6
Displays the Fader Calibration screen. (
) (TF5/TF3/TF1)
7
Displays the Channel Color Calibration screen. (
8
Closes the maintenance screen.
Initialize All Memory screen
Resets the console's memory, including Scene memory and Libraries, to the factory default
settings.
1
INITIALIZE button
Initializes the internal memory.
The following data is initialized: all Scene data, all Preset data, mixing data, and setup
data.
Touch to display the confirmation message. Touch the OK button to perform the
operation.
Do not touch any buttons until the initialization is complete.
When initialization is complete, you can continue to use other maintenance features
without exiting.
Using the maintenance screen
1.
Turn on the console while pressing the Home key (
).
The maintenance screen is displayed.
Touch the button that corresponds to the desired maintenance feature.
Touch the Exit button to exit the maintenance mode.
ձ
ղ
ճ
մ
յ
ն
շ
ո
NOTE
• When initializing the internal memory, all data stored in the memory will be lost. Use caution when
performing this operation.
• The internal clock, network settings, and brightness settings are not initialized by this operation.
• If an NY64-D is installed, we recommend you turn the TF series console off and on again so the
console will be set up correctly with the connected Dante devices.
ձ
