47
En
English
AD
V
A
NCED
OP
ERA
TI
ON
Configure the system settings of the unit while viewing the front display.
1
Turn off the unit.
2
While holding down RETURN on the front
panel, press
A
(power).
3
Rotate SELECT/ENTER to select an item.
4
Press SELECT/ENTER to select a setting.
5
Press
A
(power) to set the unit to turn off and
turn it on again.
The new settings take effect.
Change the unit’s speaker impedance settings depending
on the impedance of the speakers connected.
Settings
When using multiple receivers in the same room, setting
the remote control ID of this unit to ID1 (and setting the
another receiver to other than ID1 can prevent interference
from other remote controls.
Settings
ID1, AUTO (default)
Restores the default settings for the unit.
Choices
Configuring the system settings (ADVANCED SETUP menu)
ADVANCED SETUP menu items
Item
Function
Page
SP IMP.
Changes the speaker impedance
setting.
REMOTE ID
Selects the unit’s remote control ID.
INIT
Restores the default settings.
UPDATE
Updates the firmware.
VERSION
Checks the version of firmware
currently installed on the unit.
VOLUME
PURE DIRECT
RETURN
CONNECT
PU
S
H - ENTER
TUNING
PRE
S
ET
BAND
MEMORY
CLEAR
BA
SS
INPUT
5V
1A
BALANCE
L
R
TREBLE
LOUDNE
SS
FLAT
-
3
0dB
DIMMER
MODE
DI
S
PLAY
S
ELECT
PHONE
S
S
PEAKER
S
A
B
A
(power)
SELECT/ENTER
RETURN
DISPLAY
Changing the speaker impedance
setting (SP IMP.)
4
MIN
Select this option when you connect speakers with
an impedance of 4 ohms to less than 8 ohms to the
unit.
8
MIN
(Default)
Select this option when you connect speakers with
an impedance of 8 ohms or more to the unit.
Selecting the remote control ID
(REMOTE ID)
Restoring the default settings (INIT)
ALL
Restores the default settings for the unit.
NETWORK
Initialize all of the network,
Bluetooth
and USB
settings. When performing the initialization, the
preset (p. 41) registered by NET/USB input will
be cleared.
CANCEL
Does not perform an initialization.
SP IMP.••8¬MIN
REMOTE ID•AUTO
INIT••••CANCEL
