Yamaha PSR-E433, Owner'S Manual

Page: 13 / 68

13
PSR-E433 Owner’s Manual
Setting Up
Set
ting Up

Setting the battery type
After installing the new batteries then turning the
power on, make sure to set the Battery Type to
Rechargeable type or not. For details, refer to page 50.

Checking the power status on the
display

Power source on the display
You can confirm the power source at the left corner of
the display.
When is shown, the power is supplied from the
AC power adaptor. When is shown, the power is
supplied from the batteries. When the AC power adap-
tor is connected with the batteries installed, the power
is supplied from the AC power adaptor and the
indication is shown.

Remaining battery power indication
You can confirm the approximate amount of remain-
ing battery power at the top left of the display.
Connecting Headphones or
External Audio Equipment
Any pair of stereo headphones with a 1/4” stereo
phone plug can be plugged in here for convenient
monitoring. The speakers are automatically shut off
when a plug is inserted into this jack.
The PHONES/OUTPUT jack also functions as an
external output. You can connect the PHONES/OUT-
PUT jack to a keyboard amplifier, stereo system,
mixer, tape recorder, or other line-level audio device
to send the instrument’s output signal to that device.
Connecting a Footswitch to the
SUSTAIN jack
You can produce a natural sustain as you play by
pressing an optional Footswitch plugged into the
[SUSTAIN] jack.
• Failure to set the Battery Type may shorten the amount of
the battery life. Make sure to set the Battery Type correctly.
Indicates that the power will be turned off
immediately. When rechargeable batteries are
used, this icon flashes before the power is
turned off.
Indicates that remaining power is insufficient
for operation. Before the power runs out,
replace all the batteries with new ones, or fully
recharged ones (when using rechargeable
types). Note that the instrument may not work
properly, including unusually soft volume and
poor sound quality when remaining power
becomes low.
Indicates that the remaining power is suffi-
cient.
NOTICE
Only one of these is shown.
GrandPno
• Do not use the instrument/device or headphones for a long
period of time at a high or uncomfortable volume level,
since this can cause permanent hearing loss. If you experi-
ence any hearing loss or ringing in the ears, consult a phy-
sician.
• Before connecting the instrument to other electronic com-
ponents, set all volume levels to the minimum, then turn
off the power for all components.
• When the instrument’s sound is output to an external
device, first turn on the power to the instrument, then to
the external device. Reverse this order when you turn the
power off.
• The sustain function does not affect split voices (page 17).
• Make sure that the footswitch plug is properly connected to
the SUSTAIN jack before turning on the power.
• Do not press the footswitch while turning the power on. Doing
this changes the recognized polarity of the footswitch, result-
ing in reversed footswitch operation.
CAUTION
NOTICE
NOTE