Chapter 2: Getting Started
10
En
Speaker cables consist of two insulated wires running
together. Speaker connections are polarized and use
positive (+) and negative (–) terminals that are color-
coded red and black, respectively. To help you
connect the wires correctly, the positive wire is
usually marked with a stripe or some other identifier.
All you need to do is to connect the marked wire to
the positive (+) terminals on the DRX-730 and
speakers, and connect the unmarked wire to the
negative (–) terminals. If you get them crossed over,
your speakers will be out of phase and the sound will
be unnatural and lack bass, so take care.
1
Strip about 10 mm (3/8 in.) of insulation from
the end of each wire, and twist the exposed
strands together to prevent possible short
circuits.
2
Push open the speaker terminal lever, insert
the wire into the hole, and then close the lever.
You can connect a powered subwoofer (sold
separately) to the DRX-730’s SUBWOOFER OUT
jack for a really deep bass sound.
Using an audio pin cable (sold separately),
connect the DRX-730’s SUBWOOFER OUT jack to
the powered subwoofer’s input jack.
Notes:
• Do not connect the power cables to the DRX-730
and powered subwoofer until all other
connections have been completed.
• The SUBWOOFER OUT jack outputs the low-
frequency sounds of a downmix created from all
of the channels available in the source material.
Connecting speaker cables
10 mm (3/8 in.)
Red: positive (+)
Black: negative (–)
Connecting a powered
subwoofer
INPUT
INPUT
HDMI
MAINS
AM
ANT
ANT
GND
FM
UNBAL.
75
OUT
OPTICAL
VIDEO
OUT
IN
MIN
COMPONENT
DIGITAL
DOCK
AV MONITOR OUT
AUX
OUT
SUBWOOFER
SPEAKERS
VIDEO OUT
P
Y
R
P
B
R
R
SPEAKER
6
Audio pin cable
Powered
subwoofer
(Europe model shown here.)
Summary of Contents for PianoCraft DRX-730
Page 626: ...Printed in Malaysia WQ26630 1 IP ...