P-200
11
18
Assembling the Keybed
18-A Place the keyboard assembly upside-down,
insert a hammer assembly into the frame, and
put the stopper on. (Fig. 14)
* There are four (4) weights of hammers.
18-B Place the keyboard assembly rightside up. Fix
key springs on the frame by setting one at each
slit and pushing down once on each key?
spring?. (Fig. 14 and Fig. 15)
* Be careful of the direction of the spring.
18-C After a key has been fit to part [F] and key
guide, make sure that the spring is fixed to the
key and then press down part [E] of the key.
(Fig. 16)
18-D Tighten the seven (7) screws marked [260A] to
fix the GH-D SW (L) circuit board. (Fig. 9)
18-E Tighten the ten (10) screws marked [260B] to
fix the GH-D SW (H) circuit board. (Fig. 9)
* Install the circuit boards in the keyboard
assembly so that the hooks hold it as shown in
figure 17.
(Fig. 13)
Hammer, white key
Stopper (L88)
(Fig. 14)
(Fig. 15)
Spring
Frame
Frame
Hook
Hammer, white key
Stopper (L88)
up
