English
E-
11
1
Set the VOLUME control to minimum (0).
2
Turn on the power supply to all the
components.
3
Play a source and adjust the amplifier’s
volume control to the desired listening level.
4
Increase the volume gradually to adjust the
volume balance between the subwoofer and
the main speakers.
Note: It is recommended to set the
VOLUME control to the middle
position when using all the
speakers of this package in a 5.1-
channel home theater system.
m
Adjusting the subwoofer before use
Before using the subwoofer, adjust the subwoofer to obtain the optimum volume balance between the subwoofer and the main
speakers by following the procedures described below.
Rear panel
Once the volume balance between the subwoofer and
the main speakers is adjusted, you can adjust the
volume of your whole sound system by using the
amplifier’s volume control.
However, if you change the main speakers NX-210P to
others, you must make this adjustment again.
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
INPUT2
/MONO
AUTO
STANDBY
STANDBY-RED
ON-GREEN
OFF
LOW
HIGH
OFF
POWER
ON
2
VOLUME
0
I0
OFF
POWER
ON
AUTO
STANDBY
STANDBY-RED
ON-GREEN
OFF
LOW
HIGH
VOLUME
0
I0
1, 4
VOLUME
0
I0
Automatic power-switching function
When you play a source, the power of the subwoofer turns
on automatically by sensing audio signals input to the
subwoofer. On the other hand, the subwoofer automatically
switches to the standby mode if the source being played is
stopped or the input signal is cut off for a few minutes.
This function operates by sensing a certain level of low
frequency input signal. Its sensitivity is high in the HIGH
position and low in the LOW position of the AUTO
STANDBY switch. Set this switch to the position you prefer.
In the HIGH position, the power will turn on even with a low
level of input signal. But please be aware that the subwoofer
may not switch to the standby mode when there is an
extremely low input signal.
* The power might turn on unexpectedly by sensing noise
from other appliances. If that occurs, set the AUTO
STANDBY switch to the OFF or LOW position.
* The level of low frequency input signal differs with each
source and among different parts within the same
source. This means that the function may not operate
properly on some sources.
This function is available only when the power of the
subwoofer is on (by setting the POWER switch (
1
) to
“ON”).
