3
En
SPEAKERS
A
B
L
R
+
+
–
–
CONNECTIONS TO YOUR AMPLIFIER
Amplifier
NS-F901 (L)
This speaker system is capable of standard connections and bi-wired connections. Before making
connections, make sure that the amplifier is switched off.
■
CONNECTIONS
You need a commercially available speaker cable.
y
The size and/or material of a speaker cable affects on the
sound quality. Therefore, we recommend you to purchase
a high-quality speaker cable to exert the performance of
this unit.
Notes
•
Connect the (+) terminals on the amplifier and the
speakers using one side of the cable. Connect the
(–) terminals on both components using the other
side of the cable.
•
Connect one speaker to the left (L) terminals of
your amplifier, and another speaker to the right (R)
terminals, making sure not to reverse the polarity
(+, –). If one speaker is connected with reversed
polarity, the sound will be unnatural and lack bass.
•
When using an amplifier with a rated output
power higher than the nominal input power of the
speaker, care should be taken never to exceed the
speaker’s maximum input.
•
The speaker may be damaged if certain sounds
are continuously output at high volume level.
For example, if sine waves from a test disc, bass
sounds from electronic instruments, etc., are
continuously output, or when the stylus of a
turntable touches the surface of a disc, reduce the
volume level to prevent the speaker from being
damaged.
•
Please refer to the owner’s manual that came with
your amplifier or receiver.
How to connect the cables:
1
Loosen the knob.
2
Remove 15 mm (5/8”) of insulation from each end of
the cables, and twist the exposed conductors together
neatly and tightly, as shown below.
15 mm
(5/8")
3
Insert the bare wire into the hole.
4
Tighten the knob and secure the cables.
5
Test the firmness of the connection by pulling lightly on
the cables at the terminal.
Notes
•
Do not let the bare speaker wires touch each other
as this could damage the speaker or the amplifier,
or both of them.
•
Do not insert the insulation coating into the hole.
The sound may not be produced.
<Standard connections>
Jumper cable
Leave the jumper
cables in place
when connecting.
NS-F901 (R)
Speakers
terminals of
the amplifier
Loosen
Tighten
Insulation coating
Bare wire
