4
En
Removing / Attaching the grille
■
When using a banana plug
1
Tighten the terminal knob.
2
Simply insert the banana plug into the terminal.
The front cover is fastened to the enclosure at six points and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the speaker. To reattach, line up the six holes on the speaker with
the six corresponding pegs on the inner surface of the cover and push gently.
Notes
• When removing or attaching the grille, be careful not
to touch the drive units, and not to exert excessive
force with any tools.
• Do not touch or apply impact to the speaker’s
diaphragm. Otherwise, the speaker may
malfunction.
• To avoid damaging the grille, never apply excessive
force, and be sure to use its frame, never pull or push
the surface, for removing or attaching the grille.
Type
.................................................................... 2-way bass reflex
Non-magnetic shielding type
Driver
............................. Woofer: 16 cm (6-1/2") cone type x 2
Tweeter: 3 cm (1") soft dome type
Nominal input power
......................................................... 50 W
Maximum input power
.................................................... 300 W
Impedance
............................................................... Nominal 6 Ω
Frequency response
........................... 30 Hz - 36 kHz (–10 dB)
- 100 kHz (–30 dB)
Sensitivity
.........................................................87 dB/2.83 V, 1 m
Dimensions (W x H x D)
............................ 218 x 1042 x 369 mm (8-5/8" x 41" x 14-1/2")
Weight
................................................................... 19 kg (41.9 lbs)
Specifications are subject to change without notice.
Banana plug
Removing / Attaching the grille
Specifications
