CONNECTION TO
YOUR AMPLIFIER
BEFORE MAKING CONNECTIONS, MAKE SURE
THAT THE AMPLIFIER IS SWITCHED OFF.
m
CONNECTIONS
• Connect the push-type input terminals at the rear of
the speaker to the speaker output terminals of your
amplifier with speaker cables.
• Make sure not to reverse the polarity (+, –). If
connected with reversed polarity, the sound will be
unnatural and lack bass.
Procedures:
1
Press the tab on the terminal down, as shown in
the figure.
2
Insert the bare wire end properly into the terminal
hole. [Remove approx. 5 mm (1/4”) insulation
from the speaker cable.]
3
Remove your finger from the tab to allow it to lock
snugly on the cable’s wire end.
4
Test the security of the connection by tugging
lightly on the cable at the terminal.
Note
Do not let the bare speaker wires touch each other
as this could damage the speaker and/or the
amplifier.
SPECIFICATIONS
Type ....................................Acoustic-suspension type
Magnetic-shielding type (EIAJ)
Speaker Unit ............10 cm cone woofer (JA1065) x 2
2.5 cm balanced dome tweeter (JA05R4) x 1
Crossover ..........................................6 kHz (6 dB/oct)
Input Terminal .............................................Push-type
Nominal Impedance .........................................6 ohms
Frequency Response ..........................80 Hz – 20 kHz
Nominal Input Power ............................................40W
Music Input Power ................................................80W
Sensitivity ...................................................90 dB/w/m
Dimensions (WxHxD)...................445 x 135 x 166 mm
(17-
1
/
2
” x 5-
5
/
16
” x 6-
9
/
16
”)
Weight ...........................................3.3 kg (7 lbs. 4 oz.)
* Specifications subject to change without notice due
to product improvements.
* Care should be taken not to exceed the input power
values noted above.
VQ04130-0 BWWR, BB Printed in Japan
Press tab
NS-C80
Center speaker
output terminals
of the amplifier
