NS-AP2600
5
Positioning the center speaker
Place the center speaker on top of the TV, on the floor in front of the TV, or inside the TV rack so that it is stable.
When placing the speaker on top of the TV, put the provided fasteners at four points on both the bottom of the
speaker and on top of the TV to prevent the speaker from falling.
Notes
Do not place the speaker on top of the TV if the area is smaller than the bottom area of the speaker. The
speaker may fall and might cause personal injury.
Though this speaker is a magnetically shielded type, there may be some influence on a TV picture depending
on the type of TV or the placement of the speaker. In such a case, place the speaker apart from the TV so
that there is no influence on the TV picture.
Wall mounting for the center speaker
Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting
bracket on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the “key hole” opening.
WARNING
The center speaker weighs 2.6 lbs (1.2 kg). Do not mount the speaker on thin plywood or wall with soft
surface material, since the screws may pull away from the surface and fall. This will damage the speaker and
can cause personal injury.
Do not install the speaker to a wall with nails, adhesives, or any other unstable hardware. Long-term use and
vibrations may cause them to fall.
To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor
molding.
Secure installation is the purchaser's responsibility.
Speaker on top of the TV
Speaker inside
the TV rack
TV set
Min
1”
3/8”
Tapping screw
(Available at the hardware store)
Wall / wall support
When using speaker brackets to mount the speakers on a wall or celling, it is strongly recommended
that safety wire, which may be included with the bracket, be used between the speaker and the
bracket to prevent the speaker from falling.
5-3/4” (145 mm)
2-3/8” (60 mm)
A screw with a diameter of 1/4” can be
used
(Hole depth: 9/32”)
You can also use the screw holes on
the back of the speaker for installing
the speakers on commercially
available speaker brackets.
1
2
Fasteners
