background image

English

E-

5

The front cover is fastened to the enclosure at six points
and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the
speaker. To reattach, line up the six holes on the inner
surface of the cover with the six corresponding pegs on the
speaker and push gently.

Note
When the cover is removed, take care not to touch the
speaker units with your hands or to exert excessive
force with tools.

SPECIFICATIONS

Type ............................. 3-way bass reflex speaker system

Magnetic shielding type

Driver ......................................... 16 cm (6.5”) cone woofer

16 cm (6.5”) cone mid-woofer

3 cm (1”) dome tweeter

Impedance ................................................................... 6 

Frequency Response ................................ 40 Hz to 50 kHz

Nominal Input Power ................................................ 100 W

Maximum Input Power .............................................. 300 W

Sensitivity ................................................... 90 dB/2.83 V/m

Crossover Frequency ................................... 500 Hz, 3 kHz

Dimensions (WxHxD) ....................... 200 x 1000 x 328 mm

(7-7/8” x 39-3/8” x 12-15/16”)

Weight ................................................. 21 kg (46 lbs. 3 oz.)

  (Including the stands)

Accessories ................................... Stand x 4 (L x 2, R x 2)

  Screw (6mm) x 4

 Wood screw (4mm) x 4

Pad  x 4

Specifications subject to change without notice due to
product improvements.

Care should be taken not to exceed the input power
values noted above.

REMOVING THE FRONT COVER

 Using as 2ch stereo speakers

Better stereo images will be obtained when the speakers
are slightly angled in towards the listeners.

 Using as main speakers in a multi channel

system

Position the speakers on both sides of the TV. The
positioning of speakers is important, because it controls the
whole sound quality of a multi channel system. Set up the
speakers on the basis of your listening position by following
the owner’s manual supplied with your amplifier.

Note
This speaker features a magnetically shielded design,
but there is still a chance that placing it too close to a
TV set might impair picture color. Should this happen,
move the speaker away from the TV set.

PLACING THE  SPEAKERS

Subwoofer

Center

NS-515F

NS-515F

Rear effect

NS-515F ENG(02.8.21)a

02.8.21, 8:39 PM

5

Summary of Contents for NS-515F







Reviews: