Yamaha NMAX 155, Owner'S Manual

Page: 50 / 108

Instrument an d control functions
6-17
6
To use the power outlet
1. Turn the vehicle power off.
2. Remove the power outlet cap.
3. Turn the accessory off.
4. Insert the accessory plug into the
power outlet.
5. Turn the vehicle power on and
start the engine.
6. Turn the accessory on.
TIP
When finished riding, turn off the ac-
cessory and disconnect it from the
power outlet, and then install the cap.
WARNING
EWAN0050
To prevent electrical shock or short-
circuitin
g , install the cap when the
power outlet is not in use.
EAU15306
Si d estan d
The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
EWA10242
The vehicle must not b e ri dd en with
the si d estan d d own, or if the si d e-
stan d cannot b e properly move d up
(or d oes not stay up), otherwise the
si d estan d coul d contact the g roun d
an d d istract the operator, resultin g
in a possi b le loss of control.
Yamaha’s i g nition circuit cut-off
system has b een d esi g ne d to assist
the operator in fulfillin g the respon-
si b ility of raisin g the si d estan d b e-
fore startin g off. Therefore, check
1. Power outlet cap
1
UB1TE0E0.book Page 17 Monday, September 9, 2019 4:44 PM