Yamaha MT8X, Operation Manual

Page: 14 / 49

REAR PANEL
MIC/LINE INPUT, LINE INPUT and INSERT I/O
Jacks
Input Impedance: 10 k , 1 0 k , 1 0 k
Rated Input Level: -10 dB to -50 dB, -10 dB, -10 dB
MIC/LINE INPUT jacks are provided for channels
1-4, and only LINE INPUT jacks are provided for
channels 5-8. (For channel 8 only, stereo input jacks
are provided.) In addition, INSERT I/O jacks are
provided for channels 1 and 2.
The Insert I/O cable as shown in the following figure
is required when using INSERT I/O.
AUX SEND 1 and 2 Jacks
Output Impedance: 1 k
Rated Output Level: -10 dB (at 10 k load)
These jacks output signals to be input to external
signal processors.
POWER Switch
This switch turns the power supply to this unit on and
off.
Always make sure that the STEREO fader is set to
"0" and the MONITOR/PHONES control is set to
"MIN" when turning this unit on or off.
MONITOR OUT Jacks
Output Impedance: 1 k
Rated Output Level: -10 dB (at 10 k load)
The same signal which is output from the PHONES
jack is also output from these jacks. They can be
used for connecting a speaker with built-in amplifier,
etc.
AC IN Socket
Connect the supplied power cord here.
STEREO OUT Jacks
Output Impedance: 1 k
Rated Output Level: -10 dB (at 10 k load)
For mixdown, connect these jacks to the stereo tape
deck.
AUX RETURN 1 and 2 Jacks
Input Impedance: 20 k
Rated Input Level: -10 dB (AUX RTN LEVEL control nominal)
These jacks input signals from external signal
processors. These jacks are stereo jacks, so that a
stereo signal processor with one input and two
outputs can be connected. If using a signal
processor with monaural output only, connect to the
L (MONO) side of these jacks.
If not using a signal processor, these jacks can be
used as stereo input jacks.
2TR IN Jacks
Input Impedance: 1 0 k
Rated Input Level: -10 dB (MONITOR/PHONES control nominal)
The signals can be monitored by way of this unit if
the LINE OUT jacks of the tape deck are connected
to these jacks and the MONITOR SELECT switch is
set to 2TR IN.
TAPE OUT Jacks (1-8/SYNC)
Output Impedance: 100
Rated Output Level: -10 dB (at 10 k load)
The sounds for each track are output from these
jacks directly. During playback, the sounds from the
tracks being played back are output, and during
recording, the sounds from the tracks being recorded
are output. Adjustment of output levels from these
jacks is not possible, so adjust the volume on the unit
which is connected to the respective jacks. When
performing SYNC recording, the SYNC signal is
output from the TAPE OUT 8/SYNC jack.
CAUTION (FOR CANADA MODEL)
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
13