Perio
d
ic maintenance an
d
a
d
justment
7-35
7
TIP
A rubber mallet may be useful to tap
the wheel axle out.
7. Remove the wheel.
NOTICE:
Do
not apply the
b
rake after the
wheel an
d
b
rake
d
isc have
b
een
remove
d
, otherwise the
b
rake
pa
d
s will
b
e force
d
shut.
[ECA11073]
To install the rear wheel
1. Install the wheel and the brake cal-
iper bracket by inserting the wheel
axle from the right side.
TIP
z
Make sure that the slot in the
brake caliper bracket is fit over the
retainer on the swingarm.
z
Make sure that there is enough
space between the brake pads
before installing the wheel.
2. Install the drive chain onto the rear
sprocket.
3. Install the axle nut.
4. Lower the vehicle so the rear
wheel is on the ground, and then
put the sidestand down.
5. Adjust the drive chain slack. (See
EAU25872
Trou
b
leshootin
g
Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur
during operation. Any problem in the
fuel, compression, or ignition systems,
for example, can cause poor starting
and loss of power.
The following troubleshooting charts
represent quick and easy procedures
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look
like Yamaha parts, but they are often
inferior, have a shorter service life and
can lead to expensive repair bills.
WARNING
EWA15142
When checkin
g
the fuel system,
d
o
not smoke, an
d
make sure there are
no open flames or sparks in the ar-
ea, inclu
d
in
g
pilot li
g
hts from water
1. Retainer
2. Slot
2
1
UB7DE0E0.book Page 35 Tuesday, September 18, 2018 3:25 PM
