Yamaha MT-15, Owner'S Manual

Page: 30 / 94

Instrument an d control functions
4-11
4
8. After the sixth character is set, all
characters will flash twice and the
setting mode will automatically
end.
Screen b ri g htness control mo d e
To adjust the screen brightness
1. Turn the main switch off.
2. Push and hold the “SELECT” but-
ton.
3. Turn the main switch on and then
release the “SELECT” button after
five seconds.
4. Push the “RESET” button to select
the desired brightness level.
EAU1234M
Han d le b ar switches
Left
Ri g ht
EAU54202
Dimmer/Pass switch “ / /PASS”
Set this switch to “ ” for the high
beam and to “ ” for the low beam.
To flash the high beam, push the
switch down towards “PASS” while the
headlights are on low beam.
EAU12461
Turn si g nal switch “ / ”
To signal a right-hand turn, push this
switch to “
”. To signal a left-hand
turn, push this switch to “ ”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12501
Horn switch “ ”
Press this switch to sound the horn.
EAU12663
En g ine stop switch “ / ”
Set this switch to “ ” (run) before
starting the engine. Set this switch
to “
” (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
1. Pass switch “PASS”
2. Dimmer switch “
/ ”
3. Horn switch “ ”
4. Turn signal switch “ / ”
1. Start/Engine stop switch “ / / ”
1
4
2
3
1
UB7DE0E0.book Page 11 Tuesday, September 18, 2018 3:25 PM