Instrument an
d
control functions
4-7
4
while ri
d
in
g
, the
b
rake system re-
verts to conventional
b
rakin
g
. If ei-
ther of the a
b
ove occurs, or if the
warnin
g
li
g
ht
d
oes not come on at
all, use extra caution to avoi
d
possi-
b
le wheel lock
d
urin
g
emer
g
ency
b
rakin
g
. Have a Yamaha
d
ealer
check the
b
rake system an
d
electri-
cal circuits as soon as possi
b
le.
EAU77002
Traction control system in
d
icator
li
g
ht “
”
This indicator light flashes when trac-
tion control has engaged. If the traction
control system is turned off, the indica-
tor light will come on.
When the vehicle is turned on, the light
will perform a circuit check (come on
for a few seconds and then go off). If
the light does not come on during the
circuit check, or if the light remains on,
Yamaha dealer check the vehicle.
EAU76411
Quick shift in
d
icator li
g
ht “
”
When the key is turned to “ON”, the
quick shift system (page 3-4) turns on
and this indicator light comes on.
If a problem is detected in the quick
shift system, this light will turn off and
the quick shift system will be unavail-
able. Have a Yamaha dealer check the
vehicle.
EAU73120
Immo
b
ilizer system in
d
icator
li
g
ht “
”
When the key is turned to “OFF” and
30 seconds have passed, the indicator
light will flash steadily to indicate the
immobilizer system is enabled. After 24
hours have passed, the indicator light
will stop flashing, however the immobi-
lizer system is still enabled.
The electrical circuit of the indicator
light can be checked by turning the key
to “ON”. The indicator light should
come on for a few seconds, and then
go off.
If the indicator light does not come on
initially when the key is turned to “ON”,
if the indicator light remains on, or if the
indicator light flashes in a pattern (if a
problem is detected in the immobilizer
system, the immobilizer system indica-
tor light will flash in a pattern), have a
Yamaha dealer check the vehicle.
TIP
If the immobilizer system indicator light
flashes in the pattern, slowly 5 times
then quickly 2 times, this could be
caused by transponder interference. If
this occurs, try the following.
1. Make sure there are no other im-
mobilizer keys close to the main
switch. Other immobilizer system
keys may cause signal interfer-
ence and prevent the engine from
starting.
2. Use the code re-registering key to
start the engine.
3. If the engine starts, turn it off, and
try starting the engine with the
standard keys.
4. If one or both of the standard keys
do not start the engine, take the
vehicle and all 3 keys to a Yamaha
dealer to have the standard keys
re-registered.
UB6CE0E0.book Page 7 Thursday, October 12, 2017 2:01 PM
