MONTAGE Reference Manual
165
Reference
Utility
The Utility display has four tabs; the Setting tab, the Contents tab, the Tempo Settings tab, and the Effect
Switch tab. You can make various settings for the entire system.
From the Sound display you can make overall settings for the sounds output from the instrument.
Tone Generator Volume
Determines the overall volume of the instrument.
Settings:
0 – 127
Tone Generator Note Shift
Determines the amount (in semitones) by which the pitch of all notes is shifted.
Settings:
-24semi – +24semi
Tone Generator Tune
Determines the fine tuning of the instrument’s overall sound (in 0.1 cent steps).
Settings:
-102.4 – +102.3
Sustain Pedal (Footswitch Sustain Pedal Select)
Selects the Footswitch type connected to the FOOT SWITCH [SUSTAIN] jack on the rear panel.
• When the FC3 or FC3A is used:
When you connect an optional FC3 or FC3A (equipped with the half-damper feature) for producing
the special “half-damper” effect (as on a real acoustic piano), set this parameter to “FC3A (Half on).”
If you don’t need the half-damper feature or want to disable it while still using an FC3 or FC3A, set
this parameter to “FC3A (Half off).”
• When the FC4, FC4A, or FC5 is used:
Select “FC4A/FC5.” The FC4, FC4A, and FC5 are not equipped with the half-damper feature.
Settings:
FC3A (Half On), FC3A (Half Off), FC4A/FC5
NOTE
Note that this setting is not necessary when controlling the half-damper feature via Control Change messages
from an external MIDI device to the instrument.
Settings
Sound
Operation
[UTILITY]
[Settings]
[Sound]
