Edit
MODX Reference Manual
100
Reference
From the Control Assign display you can make controller assign settings for the Part.
You can change sounds as desired by setting the desired controller to “Source” and the desired parameter
to “Destination.” Not only physical controllers such as the Pitch Bend wheel but also Motion Sequencer or
Envelope Follower can be set to “Source” as a virtual controller.
Up to 16 Controller Sets can be assigned to each Part.
Auto Select (Auto Select Switch)
Determines whether the Auto Select function for Display Filter (below) is active (On) or not (Off). When this
parameter is set to “On,” the operated Controller is automatically set in “Display Filter”. Also you can obtain
the same result by pressing the [CONTROL ASSIGN] button.
Settings:
Off, On
Display Filter
Determines the Controller to be displayed. When “Super Knob” is selected, all Assignable Knob settings to
be affected by using the Super Knob are displayed.
Settings:
PitchBend, ModWheel, AfterTouch, FootCtrl 1, FootCtrl 2, FootSwitch, Ribbon, Breath, AsgnKnob 1–8, Super Knob,
AsgnSw 1, AsgnSw 2, MS Lane 1–4, EnvFollow 1–16, EnvFollowAD, EnvFollowMst, All
Display Name
Determines the name of each Assignable Knob 1–8 which is displayed in the Performance Play display
(
). This is available only when “AsgnKnob 1–8” is set in “Source.”
Control Assign
Operation
[PERFORMANCE (HOME)]
[EDIT]
Part selection
Element [Common]
[Mod/Control]
[Control Assign]